does anybody have any ideas on how i should set up my sub box in the back of my element? where should i put the wires? would there be a way to take off the floor panelling? dumb question but i need help? thanks

The back floor cover comes up easily. There is a thread here with detailed pics and instructions. Do a search... might take awhile to find it.

Also, you can easily lift up panel covers and tuck wires under them. You onlly need to get the wires just under the edge, then push them back a bit with a screwdriver.

B

does anybody have any ideas on how i should set up my sub box in the back of my element? where should i put the wires? would there be a way to take off the floor panelling? dumb question but i need help? thanksThe floor comes up in two sections - rear is easy but the front is a little tricky (front seats need to come out). Mostly held in by the various trim pieces around the edges and under the seats . . . I used thin needle nose pliers to carefully pull the plastic/nylon "push" fasteners.

Here's the thread (I think) Blutch was recalling:

http://www.elementownersclub.com/forums/showthread.php?t=13929&page=3&pp=10

Front seat removal info here:

http://www.elementownersclub.com/forums/showthread.php?t=14586&page=2&pp=10

The floor comes up in two sections - rear is easy but the front is a little tricky (front seats need to come out). Mostly held in by the various trim pieces around the edges and under the seats . . . I used thin needle nose pliers to carefully pull the plastic/nylon "push" fasteners.

Here's the thread (I think) Blutch was recalling:

http://www.elementownersclub.com/forums/showthread.php?t=13929&page=3&pp=10

Front seat removal info here:

http://www.elementownersclub.com/forums/showthread.php?t=14586&page=2&pp=10


hey thanks for the info guys! i couldnt have done it without you!