I installed two new infinity 6 1/2 speakers with built in tweeter and the tweeter at the time i put them in stuck out too far, so i had to cut out a 2 1/2 inch whole so i could turn the tweeter and adjust the volume level...I need help with something that i can put inside the hole so you can see the edges of the cut.I tried sanding down the edges but they look like crap..

Basically i need help finding something to make the whole look better then what it does now. i was thinking of some type of ring to put there to make things look nice.

heres a pic, notice the rough edges, i want to not be able to see them.

okay may be its a 3 inch whole saw that i used

Maybe a piece of door edge trim (black or maybe chrome).
It is cheap and if you don't like you could pull it off. you can get it a any parts store.

Well you could always go to the fabric store and get some material to try and wrap it. A little time and a hot glue gun can make all the difference in the world. It shouldn't cost very much and if you dont like it then you can always peel away the glue.