I managed to put out the console to get at the allen wrench I dropped down the hole for the parking brake the other day. As well, I was able to fix up the rubber surround for the parking brake that I popped off it's mounts as I reached through to try to get at it. It's really quite easy and I thank our fellow member who posted how to do it.

Here is the console out:

http://members.rogers.com/kjcelement/images/console1.JPG

The floor moulding surrounds this, so to get any more out, you would have to lift the entire floor. When working around this, you need to be careful - there's loads of grease on the parking brake.

Here's the console sitting out. You can see that the rubber strips in the parking brake hole are looking a bit out of place.

http://members.rogers.com/kjcelement/images/console2.JPG

Here's the console upside down:

http://members.rogers.com/kjcelement/images/console3.JPG

Compare that to the following picture in which I have popped the rubber back on the mounts. They are not very sturdy, so be very careful if you do have to do this.

http://members.rogers.com/kjcelement/images/console4.JPG

You should be able to see how the rubber is properly in place again.