I'm replacing the speakers in my DX. I took off the a-pillars and there were no tweeters installed. Also no speakers or speaker wire in the rear doors. :x I was able to replace the front door speakers. Does anyone have a diagram of how to run speaker wire to the a-pillars and the rear doors? Any hints would be appreciatied.

Update, i found the connectors in the back doors & installed the speakers there. Still need to know how to connect tweeters to the head unit.

You'll need to wire them to the front door speakers. Just connect + to + and - to - then run the wire through the housing that the rest of the door wiring goes through to get to the car interior and then run it up along the inside of the kick panel and then up through the side of the dash into the A pillar area. Repeat for the other side.

Make sure you don't run full range sound to the tweeters - use a crossover or frequency filter in line with the tweeters. If you have a crossover, the best place to mount it is inside the lower dash on each side of the car. From there you can run wiring to the midbass and tweeter without having to run the tweeter wiring all the way to the door then back out and up to the dash.