alignment

If I am riding on stock height but a little bit bigger tires (225/65/R17) than stock, do you think that I would need to add front camber bolts? I recently took it in for an alignment check at 2 different shops and their numbers were completely different. That is a whole other issue in itself...

We have 165k on our 2010 E that we bought used with 79K on it 5 years ago. After 3 alignments over the the last 85k miles (after new tires, new struts, etc.), the car has always required slightly more effort to turn right than left. It will likewise drift slightly left on an even road. We've...

I replaced my outer tie-rod ends about a month ago and tightened them just enough so the cotter pin hole aligned with the castle nut. Car rides fine but now get a single "click" sound when I am making a really tight turn. I think I might need to tighten down that tie-rod end a bit more, anyone...

Hello Group Some one punctured my left front sidewall the other day. I found this out after noticing the tire going flat ( do not drive daily, vehicle sits in driveway next to sidewalk ), I assumed I had driven over something, change to my full size spare ( new never used ), drove to the local...

Hey there! I'm new to the forum...long time lurker, first time poster. anyways, My E was taken in 1 month ago for new rodors & brakes and because the check Engine light came on. Service shop found nothing wrong anything else but did say i needed new tires (engine light turned off about 30min...

I put my new summer tires on and thought I ought to check the alignment, even though I have had not symptoms of the E being out of align. The dedicated alignment shop said: FRONT right was 1.5 negative and the left was .5 negative... spec calls for .25 negative. No big deal. REAR The rear camber...

SUSPENSION MOTHERLOAD!:evil: here is a compilation of suspension related threads that i gathered now that we have "suspension" added to the tire and wheel section. (Thanks again Tmac!):cool: if anyone knows of any threads i've missed (i'm sure i have) please feel free to reply to this thread...