Honda Element Owners Club banner
1 - 3 of 3 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
i just finish installing my system. i took the drivers seat out to run the wires under the floor mat. so i disconnected the seatbelt wire and the air bag wire. now the freekin air bag light stays on. when i turn the engine on. i tried to unplug the battery and reset it but no luck. does anyone have a clue on how to reset the air bag sensor?
 

·
Retired.
Joined
·
12,183 Posts
only one way to have it reset...........take it back to the dealer....they will have to hook it up to their diagnostic checker to reset the light.
 

·
Registered
Joined
·
352 Posts
Yup - lizzurd is right. The warning light turn off sequence is a timed procedure and typically requires the dealer to do it. What probably got you was that you disconnected the seat belt wire and then turned on the ignition. This is a big NO NO with honda products because it cause your air bag light to remain on until it is reset. I am speaking with an air of experience here - did the same thing to my 97 Civic and cost $35 to have the light reset.
 
1 - 3 of 3 Posts
Top