Honda Element Owners Club banner
1 - 4 of 4 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
Howdy all. I was going to replace the cabin filters in my 03 E, but could not get the darned glove box to release and swing down. I watched a tech do it a few years ago and it seemed real simple. Tried pushing, pulling, compressing the sides etc. to no avail. Hate to break a clip because of a brain fart. I am sure this is simple. Any direction would be appreciated.

Dave
 

·
Registered
Joined
·
120 Posts
Real easy....

open the glove box, look at the clips on the outside of the glove box door, push the the two clips ends together and that will allow the clip to slide into the glovebox and repeat and the whole glove box will swing down and expose the inside of the dash.

This is the first Honda I have owned (own Audis) and this abin air filter swap took at most ten minutes from start to finish.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top