[jml]

I notice that there seem to be two groups of responses to installation of their Cloudrider screens. Some post that it was easy and takes a short time, while others say that it is difficult and takes more time. It was easy for me to insert the clips through the original plastic screen and tighten them, but reaching inside to put the locknuts on was almost impossible. Are others not using the lock nuts, or are my hands just to big to fit? Thanks for the advice. joel

 

[jml]

Isketerol, Thanks, I think I rememeber your point about rubber washers. I did remove the upper cover and the upper grill was easy. My problem was the lower grill. I could not reach the lower grill bolts from the top. I loosened but did not remove the "bottom cover" section of the front end and tried to reach in with a socket to tighten the lock nuts, but I just couldn't get my hand in to a position where I could tighten the lock nuts. joel

 

[jml]

Thanks, that's exactly what I did,b but it bothers me that the lock nuts are not finished. I was looking at a ratchet wrench where you twist the hande to rotate the socket. Perhps I'll give it a try. joel