Honda Element Owners Club banner
1 - 1 of 1 Posts

· Registered
16 Posts
Discussion Starter · #1 · (Edited)
The inner moulding of the rear tail glass piece keeps coming loose. I've replaced the middle screw but now the outer edges seem to be coming undone - only the middle screw is keeping the piece in place.

There appears to be no screws that the moulding piece in place on the sides. I guess it should click into place.

Any suggestions?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.