(I brought my tape measure when I took out the trash )

The OEM tip is 5" from end to end, almost exactly. It sits about 1/2" past the end of the pipe, leaving 4.5" on the pipe. The pipe begins the bend about 3/4" beyond the inner edge of the tip. so I'd say the tip could extend 'forward' an inch or a little more before it actually touched the pipe's bend. Long story short, you're not going to get an 8" tip on there, unless it's wide as a coffee can.

Hope that helps.

 

Thanks for doing the deed during trash-time! Yeah, I thought the stock tip seemed pretty short. Oh well. Again, my thanks!

 

Deckeader,
I cut a good portion of my tailpipe off and screwed on a Pilot tip with a square hole. Looks good and I don't have to worry about backing into a curb or log or something and crunching my exhaust system. Trust me, I did that once with my pickup and it pushed the entire exhaust to the point where it even bent the headers.
The pipe now exits below the right hand corner.

 

"Does anyone know how long the Honda exhaust finisher is?"

Well, he said he was this long, but I think he was exaggerating a bit!

[/img]

 

 

[quote:ffedfdd7d1=" "]Deckeader, ...[/quote:ffedfdd7d1]

Best tend to that rudder, er paddle, KD!

And seb:
Jeebus, what are those --- mortar launchers? That car is positively fabulicious. Bet he could slide a chair under that desk sitting on the truck as well.